nazarov@imzrb.ru
Scroll down
SMALL UNIT OF THE TYPE
«Installation of an electric centrifugal pump 2А»
«Installation of an electric centrifugal pump 2А»
Up to 12500 mm
Composition
Submersible valve motor
up to 6600 mm
- Modular design of the submersible electric motor, allowing in the shortest time to assemble the assembly of the required power up to 100 kW.
- Rotors based on high-temperature, high-power magnets.
- Stator winding with maximum operating temperature up to 200°C.
- Independent bearing support for each rotor based on carbide bearing couples.
- Ability to work in any spatial position.
Submersible valve motor
up to 6600 mm
- Modular design of the submersible electric motor, allowing in the shortest time to assemble the assembly of the required power up to 100 kW.
- Rotors based on high-temperature, high-power magnets.
- Stator winding with maximum operating temperature up to 200°C.
- Independent bearing support for each rotor based on carbide bearing couples.
- Ability to work in any spatial position.
Hydro protection unit
up to 1640 mm
- Multi-stage protection , diaphragm modules and labyrinth module with series connection and shut-off of each module by an end seal.
- Hard-alloy radial bearing supports provide extended service life.
- The use of a double-sided axial support allows operation of the hydroprotection assembly in all spatial positions.
Centrifugal pump with integrated gas separator
3500...4500 mm
- Batch assembly on carbide bearing couples, easy to assemble and reliable in operation
- Axial bi-directional bearings, operation of the centrifugal pump in any spatial position.
- Operating speed of 5000-1000 rpm, higher resistance to gas and 50% wider operating range compared with analogue pumps.
- Gas separator is factory-wired.
Centrifugal pump with integrated gas separator
3500...4500 mm
- Batch assembly on carbide bearing couples, easy to assemble and reliable in operation
- Axial bi-directional bearings, operation of the centrifugal pump in any spatial position.
- Operating speed of 5000-1000 rpm, higher resistance to gas and 50% wider operating range compared with analogue pumps.
- Gas separator is factory-wired.
Technical specifications
Advantages
IECP are three times shorter than their counterparts
Small diameter across all housings
Working with any vertical deflection
Increased number of potential shelves for IECP operation
Working area interval expanded by 50%
Working speed range from 5000 to 1000 rpm
Optimal for wells with unstable or unsteady flow
+
+
+
Disadvantages
A 500 Hz non-serial control station is required for operation
Nomenclature
Russia, the Republic of Bashkortostan,
Ishimbay town, Bogdan Khmelnitskogo street, 2
Ishimbay town, Bogdan Khmelnitskogo street, 2
CONTACTS
Deputy General Director for production of oil-submersible equipment
nazarov@imzrb.ru
Boris Leonidovich Nazarov
+7 963 235-44-42